PRODUCT CATE
Products

Move the air conditioning machines

Move the air conditioning machines

    moves is a professional air conditioning air conditioning technical work, seemingly simple move the air conditioning working, in the hands of different air conditioning moves staff have different results. Need air conditioning when you move selected specialist air conditioning machine, or more money, don't tell, and damage to air conditioning, air conditioning moves are divided into two: teardown---installation

    teardown steps:

    (1) recovery of refrigerant the refrigerant in the air conditioner must be collected in the outdoor unit. Split machine Qian started empty apoptosis device, can set refrigeration State, stay compressor running 5-10 minutes, refrigeration State normal Hou, twist Xia outside machine of liquid tube and gas tube interface Shang of insurance CAP, close high pressure tube (fine) of as valve, 1 minutes Hou tube appearance knot dew, immediately close low voltage tube (rough) as valve, with of quickly shut machine, pulled Xia power plug, with wrench twist tight insurance CAP, now recycling refrigeration agent work completed. Push start button on the indoor unit may also be used to boot, with indoor and outdoor observation of whether there were other failures. Avoid trouble after moving air conditioning machines.

    (2) after the split indoor unit refrigerant recovery, removable interior. Using a wrench lock to open the indoor units connected, with sodium prepared sealed Rotary well protect indoor unit connector threads to prevent chipped in the handling connection threads; then the cross removed the line of control. Should also be marked to avoid faulty connection at installation time. If the signal lines or power lines connected to the wrong, will cause the outside unit is not running, or the machine is not under control. Hanging plate is generally fixed more firmly, more difficult to unload; discharging remove the hanging plates, cement and then patted, correction on plane.

    (3) connection lock twist away his mother, sodium prepared sealed Rotary good designer out connector threads. Use wrench loosen the outer foot fixing screw. Demolished and then put down the outdoor machine, better to use a rope to hang, dump and should pay attention to balance, to avoid vibration, bump, and attention to safety. Slowly stroking straight outdoor air conditioner takes over, prepared four plugs seal the four ports connecting tube to prevent dust and water from entering the air. On the plug well, then tied with plastic bags, good for easy handling.

    teardown steps:

    determining internal and external position, immediately installed in the machine hangs, stay outside the machine and the machine hangs after installing firm, then smoothed the straight pipe, see if the pipe is bent flat; then check the ends flare, if cracks should be flared again, otherwise it will leak and fluorine. Finally, check the line of control in determining line, the line of control, the outlet pipe after good, banding together and connecting their mouth sealed. Over the wall when two people inside a wall, fit on the slow wearing out, avoid injury; connect the pipes with internal and external units, and connect the control line. Next, exclude air from the pipe and machine. Power on test OK now move end

PREV: Furniture Assembly and disassembly

NEXT: No informtation!

BACK